- [Narrator] The following instructional video will demonstrate the proper assembly of the Kimberly-Clark touchless electronic skincare dispenser mounting stand. Always wear appropriate protective gear and follow all safety regulations and procedures. Unpack all items prior to assembly. With the threaded portion of the lower pole facing down, attach the base of the stand to the pole using the four large screws and hex nuts provided. Using the enclosed large hex-shaped wrench, tighten all four screws to the base of the stand. Place the base upright on a flat surface. Using the large wrench with the U-shaped mounting brackets, attach the second pole to the first section of the stand. Repeat the process if the third pole is used. You are now ready to assemble the cassette tray to the mounting stand. Install the oval slides on the mounting tray. Align the slides with the channels on the mounting pole and slide down to the desired height. Make sure to tighten the slides with the small hex wrench provided. Position the cap at the top of the stand. Pre-install the top two dispenser screws and hex nuts on the mounting plate. Align the electronic cassette on the top two dispenser screws, push slightly forward, and slide the dispenser down to lock the dispenser into the keyhole slots. Install the bottom two screws and hex nuts. To complete the attachment of the soap dispenser to the mounting plate, tighten all dispenser screws securely. You are now ready to install the cassette refill in your touchless electronic skincare dispenser. For further assistance assembling, installing, or using your Kimberly-Clark Professional touchless electronic skincare dispensing system, call the Kimberly-Clark Customer Solutions Center at 1-888-346-4652.