- [Instructor] The following video displays the mounting instructions for the Coreless JRT Tissue Dispenser. Always wear appropriate protective gear and follow all safety regulations and procedures. See product insert for additional information and warnings. First, determine at what height the dispenser will be hung. KC recommends at least 30 inches from the floor to the bottom of the dispenser, and 12 inches from the front edge of the toilet to the center of the dispenser. The mounting bracket should be installed 7 inches higher than the desired location for the dispenser bottom end. Use the enclosed mounting bracket as a template. Use the bracket to determine where the screw holes will be. Mark the wall accordingly. Drill the holes and insert the wall anchors, then screw the mounting bracket into the wall. Align the dispenser over the bracket, lining up the anchors on the back with the protrusions on the bracket. Push firmly to hold in place. While the dispenser is hanging on the wall, mark the wall for the bottom two screw holes. Remove the dispenser and drill the wall for the remaining two wall anchors. Reattach the dispenser and screw in the final two holes. Use a power driver with a long bit extension for the bottom two screws. Now, you're ready to load the tissue roll.